Crease & Sharp Density Control
Auto Density
Automatically adjusts density across all connected patterns.
Full Crease Control
When OFF Crease Edge 0-1 will add more cuts to the pattern.
When ON Crease Edge 0-0.5 will reduce number of cuts of the pattern; 0.5 will be neutral; 0.5-1 will add more cuts to the pattern.
Note: Crease Control takes into account the side with most divisions, so to reduce density you need to select all of the sides of patterns (and also connected patterns)
When switching to Full Crease Control On you need crease edge at 0.5 for neutral state. Use Crease To 0.5 tool in edit mode to quickly set it up.
Density Add
Uses Edge Sharp to add cuts to mesh.
Density Add Threshold
Offsets the reach of additional cuts.
